New version 6.16 of POS released.

[Dale Harris]

The "Z" reading thing from version 6.15 under some conditions would cause a fatal error (the program would die) when the cash register was opened. This error occurs even if you are not using the "Z" reading.

If you are using version 6.15 you must upgrade to version 6.16.

Here is the download link...

<center> http://keyhut.com/pos3.htm </center>

[Guest]

well, technically you dont have to, but it just would be reccomeded

[Dale Harris]

Guest,

You are absolutely correct. You do not have to download version 6.16 if you are using 6.15. But then again you do not <u>have</u> to run out of a burning building or pull the rip cord if you are skydiving, those actions are also only "recommeded."

[flapokey]

Hello,

I have just downloaded and updated the POS program to 6.16.
I am having a error happen on the opening print portion only if I select do not print it is fine if I say print this is the error I am getting

Bad File Name or Numer in Line 0 of Module POS4 ______ at address 4852:A07F

Also when I close the reg. it does the same thing if I don't print it is fine if I say print it give me the exact same error.

Bad File Name or Numer in Line 0 of Module POS4 ______ at address 4852:A07F

Thanks flapokey

[Dale Harris]

flapokey,

The problem you are reporting happened in version 6.15 and was fixed in version 6.16. Since then a couple of people have reported that it was happening in version 6.16 also but every time I have looked into it I found out that the person with the problem was actually running version 6.15 and not 6.16.

So please check and make sure that the version that you are running actually states at the bottom of the main menu that it is 6.16.

If it is then please send to me as an attachment to an email to daleharris@prodigy.net your configuration file ????????.POS