DHES

Hi All,

I have been using the LS9100 (connected via a P/S2) for past 9 years and recently, one of my staff found the old user manual and accidently scanned something (i don't know what and he wasn't sure either ) which resulting in the scanner not able to decode (he probably jumble up all the pre-configuration ).

Tried to configure it myself but just don't know where to start and what to do as it does not utilises a software. Tried to contact the salesperson but to my dismay the shop had closed a couple of years back .

Hence, here i am seeking help from all the gurus out there who have experience with the said barcode scanner. Would greatly appreciate if you guys can help to revive it. Many thanks in advance.

Joe

If your user manual is anything like mine, the default options should be underlined. Just scan all the default options (you prob have to scan "configure" first and "exit" afterwards. There may even be a single barcode to scan that says "reset all defaults".

Hope this helps.

Dan

Sorry... should just add that my scanner is not the same as yours, its a Zebex. However, it uses PS2 port (keyboard wedge) so should work in much the same way.

Thanks for ur kind advise.

Tried ur method, but it's still not working. Just a question, do i have to scan the barcode in sequence? If so what should the sequence be? I dun know which is which? Should i be scanning RS 232 or IBM46xx? There are too many options and i am confused by it.

Btw, it doesn't begin with a "config" thingy and the manual is not written in layman's term.

Tks again.

Joe

Hi all,

Managed to find the "set all default", but still don't get anything after i scan it. Ahahahahahaha.........stupid scanner.

Urm i'll have a wee look in my barcode scanner setup guides and I'll get back to you!

I've got setup guides for most scanners.

Alan

Alan wrote:Urm i'll have a wee look in my barcode scanner setup guides and I'll get back to you!

I've got setup guides for most scanners.

Alan

Thanks Alan. I have recently contacted Symbol and they are really awesome. .... they sent me a copy of the keyboard wedge type and even gave me specific instructions on what to do, but I just do not have time to try it out myself. Been real busy..... managing my other businesses. But thanks anyway.

Problem finally solved! Horray!

Can someone please ban the above user (dawson).

these are just some of the treads hes spammed in:
*http://www.dhpos.com/discuss/phpBB2/viewtopic.php?t=952
*http://www.dhpos.com/discuss/phpBB2/viewtopic.php?t=883
*http://www.dhpos.com/discuss/phpBB2/vie ... highlight=
*http://www.dhpos.com/discuss/phpBB2/vie ... c&start=15

-peachey