Page 1 of 1
citizen iDP3540 pos receipt printer
Posted: Sat Jan 17, 2004 8:35 am
by rafi damudi
Hi every 1
I would like 2 know the commands to initialise citizen idp3540 printer, also is it neccessory to install driver for the same,and also to show messages in Customer Display unit in pos
i need this information urgent
thanks in advance
rtafi
Open cash drawer code
Posted: Sat Jan 17, 2004 9:59 am
by Dale Harris
Rafi,
Use the "Open cash drawer" feature in the POSCONFG.EXE program. Choose LPT1: as the port and then on the next page enter only 7 as the open cash drawer code. You will not need any drivers.
All the above assumes that your printer attaches to your computer through the parallel printer port and NOT the serial port. If it does use the serial port write back.
I hope this was quick enough.
iDP 3540 Printer
Posted: Sat Jan 17, 2004 6:41 pm
by okiepc
Dale, the iDP 3540 citizen printer is a serial printer, I know as I have 2 of them in use, so I know it can be done.
Off hand, I think yes, a driver had to be installed for this to work. I will do some research, its has been a long time since I initially set these up.
okiepc
Aha
Posted: Sun Jan 18, 2004 11:02 am
by Alan
The iDP3540P is the parallel version - check the model number and get back to us.
Alan